![]() The top and bottom values aren't important, if you're just going to maximize the RDP window. ![]() It doesn't matter what those values are if the RDP window is always going to be maximized, as long as they are on the same screen. RDP file to set both the left and right values to positions that are on the same monitor. Note that if the secondary monitor is to the left of the primary one, the left edge of the secondary monitor will be a negative value.Ģ) Edit the winposstr setting in your. Secondary (right) monitor: Left edge: 1680, Right edge: 3599 (1680 + 1920 - 1, since the position is 0-based). Primary (left) monitor: Left edge: 0, Right edge: 1679 (not 1680 because the horizontal position is 0-based, not 1-based) So the edges of the two monitors will be: RDP file to maximize an RDP session on a particular monitor:ġ) Determine the left and right edges of each of your monitors, based on their resolution and which monitor is the primary one. The TechNet article How to Set the Monitor for a Remote Desktop Session in a Multi-Monitor Setup has a good explanation.īy the way, the article uses clearer names for the positions, I think, that have been used in other answers here: "winposstr:s:0,1,left,top,right,bottom", where horizontal values are measured from left to right and vertical values from top to bottom.Īs far as I can see, from the article and from experimenting with a RDP file in Windows 8.1, here's how to edit the. ![]() RDP file seemed promising but I was confused by the explanation of how the position values should be calculated. The other answers which mentioned editing the winposstr setting in the.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |